Closing design validation without repeat testing
A medical device manufacturer needed material declarations for a cable assembly before validation could be signed off. The previous supplier could not provide them.
Read case studyCase Studies
Application problems we have solved, described honestly — what failed, why it failed, and what the replacement actually changed. Each study links back to the parts involved.
Extending cable life on a robot wrist joint
Cables on a six-axis robot wrist were being replaced every three to four months. The fix was a construction change and a routing change, not a…
Read case studyDoubling port density in an AI training cluster
A research cluster had run out of switch ports but not rack space. Stacked 400G connectors solved the constraint without a chassis refresh.
Read case studyKeeping a discontinued test fixture in service
A semiconductor handler needed a high-cycle board interface that the original supplier had discontinued. The alternative was a fixture redesign — until we found a drop-in…
Read case studyEliminating frame drops in a vision inspection cell
A Camera Link cell started dropping frames after new drives were installed nearby. The camera, the frame grabber and the software were all blamed before the…
Read case studyEnding recurring encoder alarms on a packaging line
A high-cycle packaging axis was throwing encoder alarms every few weeks. The cause was not the drive — it was the pair geometry of the replacement…
Read case studyHave a problem worth writing up?
Describe the failure and we will tell you honestly whether it is an interconnect problem — and what we would change.